
DCN Next Generation Open Interface Release 2.4 Simultaneous Interpretation
en | 171
Bosch Communications Systems | 2007 February | SRS_ININF | Du030905
APPENDIX B. ERROR CODES 1
Responses returned upon a remote function request contain an error field (‘wError’). In this 2
appendix an overview is given of the possible errors and their values. 3
4
Simultaneous Interpretation Error code Value (hex.)
Explanation
IN_E_NOERROR
0 (0x00)
The execution of the remote function was successful.
IN_E_UNKNOWN_INTSEAT
514 (0x202)
The combination Booth and Desk was not recognized as an
interpreter seat in the system.
IN_E_INTERLOCK_NOT_ALLOWED
528 (0x210)
The requested interlock mode is not allowed in the current
configuration.
IN_E_INCONTROL_THIS_CHANNEL
529 (0x211)
The IN application is already controlled by this remote controller (on
the same channel). Probably the IN_C_START_IN_APP is called
for the second time.
IN_E_INCONTROL_OTHER_CHANNEL
530 (0x212)
The IN_C_START_IN_APP function could not finish because the IN
application is already controlled by another remote controller using
another channel.
IN_E_NOT_IN_CONTROL
531 (0x213)
The IN_C_STOP_IN_APP function cannot function, because this
remote controller does not control the IN application.
IN_E_WRONG_PARAMETER
532 (0x214)
The value of a parameter passed in a function call is invalid (out of
range).
IN_E_APP_NOT_STARTED
533 (0x215)
Indicates that no remote controller has taken over the IN application
control from the CCU (and therefore the remote controller is not
allowed to call the remote function).
IN_E_INCORRECT_DESK_CONFIG
534 (0x216)
Indicates that the desk configuration is incorrect, i.e. the mapping of
unit identifiers to booth and desk numbers passed in the remote
function does not correspond to the actual mapping inside the CCU.
IN_E_UNKNOWN_BOOTH_NR
535 (0x217)
Booth is not known in the system.
5
Commenti su questo manuale