Bosch K2200 Series Guida di Installazione Scaricare il pdf (Pagina 42)

K2200 Series | Installation Guide | 6.0 Configuration and Testing EN | 42

Bosch Security Systems | 7/03 | 17375 1.3 / 46513C

6.1.4 SYSTEM START Command

1. From the CMD prompt, type SYSTEM START

and press [ENT]. (Press [SPC] between SYSTEM

and START).

CMD SYSTEM START

2. This message will appear briefly:

ERASE ALL DATA

Type [Y] and press the [ENT] key.

3. These two messages are displayed as the memory

is cleared.

ERASING USE DATA

and

ERASING SYS DATA

End of process. Proceed to the INST Command

section.

Note:

The SYSTEM START command will end at

the first prompt of the INST command.

6.1.5 INST Command

For a Standalone Master Controller (no software

used):

Option Switches (Standalone Master Controller)

The option switches are fitted at the bottom right of

the circuit board.

For a Master Controller, the top 3 switches must be

set as shown in Figure 30. Switches 1 to 3 should be

set to in Figure 30.

Figure 30: Master Controller DIP Switches

1. At the CMD prompt, type in INST and press the

[ENT] button.

CMD INST

2. At PC ADMIN USED, press [N].

PC ADMIN USED N

Press [ENT] to save, press [NXT] to go on.

3. At MASTER DC, press [Y].

MASTER DC Y

Press [ENT] to save, press [NXT] to go on.

4. Set the POLL table for other salve controllers.

To poll controller 2, press the 2 and the [ENT]

key.

POLL ---

Press [ENT] to save, press [NXT] to go on.

5. Present a key to the faceplate reader. Numbers

will appear.

E0 KEY 00000000

Press [ENT] to save, press [NXT] to go on.

6. A password can be set to further protect the

Master Key. Type in the password (8 characters

max).

PASSWORD

Press [ENT] to save, press [NXT] to go on.

7. This is an identity for the master key. If you print

transactions, this identity will appear against

editor operations and alarm acknowledgements.

i.e - MASTER.

ID MASTER

Press [ENT] to save, press [NXT] to go on.

8. This allows the entry of a 12-character name

when adding keys. Type in Y.

ALPHA ID Y

Press [ENT] to save, press [NXT] to go on.

9. For the PRINTER TYPE:

Type 0 if you are using an Epson or IBM

compatible p

Type 1 if the printer is an OKI Microline.

PRINTER TYPE 0

Press [ENT] to save, press [NXT] to go on.

10. Sets the format in which dates appear in the

system:

Type 0 for 'dd-mm-yy' (European style).

Type 1 for 'mm-dd-yy' (US style).

DATE FORMAT 1

END OF SETUP. Press [ESC] to exit back to CMD

prompt.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 59 60

Commenti su questo manuale

Nessun commento