Bosch APC-AMC2-4WCF Manuale di Installazione Scaricare il pdf (Pagina 17)

AMC2 4W | Installation manual Introduction | en 17

Bosch Sicherheitssysteme GmbH F.01U.024.965 | V 0.1 | 2006.03

3.2 Equipment Configuration

Fig. 3.3 Upper circuit board with display (top side)

1. Internal tamper contact

2. DIP switch for RS-485 address selection, protocol and RS-

232/RS-485 selection

3. Lithium battery for buffering of static RAM and real time

clock (RTC). The battery shall be replaced by qualified per-

sonnel every ten years or if indicated by an appropriate

event.

4. Reset push button - available by using the srew driver

5. LC Display

6. Push button to select the display view - available by using

the push button on the top of the housing

7. Jumper: Potential equalization between different mass sys-

tems and protective earth (shield)

8. Jumper: interface selector RS-485 Host connection, RS-

485 two wire or RS-485 four wire (depends on external

wiring)

9. Configurable RS-485 host interface (pluggable screw con-

nector)

10. Docking station for the compact flash

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Nessun commento

Bosch APC-AMC2-4WCF Manuale di Installazione Pagina 17