Bosch D1255RB Guida di Installazione Scaricare il pdf (Pagina 30)

D9412GV2/D7412GV2 | Operation and Installation Guide | 7.0 Telephone Connections

30 Bosch Security Systems, Inc. | 7/09 | F01U003641-04

7.0 Telephone Connections

7.1 Registration

The Bosch Security Systems, Inc. D9412GV2 and

D7412GV2 Control Panels are registered with the

Federal Communication Commission (FCC) under

Part 68, for connection to the public telephone system

using an RJ31X or RJ38X jack installed by the local

telephone company.

An RJ31X jack can be modified by placing

a jumper wire between Terminals 2 and 7 to

become an RJ38X jack.

7.2 Notification

Do not connect registered equipment to party lines or

coin-operated telephones. Notify the local telephone

company and provide the following information before

connecting the control panel to the telephone

network:

• The particular line to which the control panel will

be connected

• Make (Bosch Security Systems, Inc.), model

(D9412GV2 or D7412GV2), and serial number of

the control panel

• FCC registration number: AJ9MUL-46532-AL-E

• Ringer equivalence for the control panel: 0.4B

7.3 Location

To prevent jamming of signals, wire the RJ31X or

RJ38X jack before the in-house telephone system to

support line seizure (Figure 11). Install the jack on the

street side of the telephone switch, wired ahead of

any PBX equipment. Line seizure temporarily

interrupts normal telephone usage while the control

panel sends data. After installation, confirm that the

control panel seizes the line, acquires dial tone,

reports correctly to the receiver, and releases the

telephone line to the in-house telephone system.

Figure 11: RJ31X Wiring

45 8

RING (red)

TIP (green)

RJ31X

1 - RJ31X Jack

2 - (TIP)

3 - (RING)

4 - Telco connector block

5 - Outside telco

6 - Premises telephone

7.4 Telephone Cord Connection

Connect one end of a D161 (2.1 m [7 ft.]) or a D162

[61 cm (2 ft.)] Telephone Cord to the telco cord

connector located on the bottom left corner of the

control panel. Refer to Figure 12. Connect the other

end to the RJ31X or RJ38X jack.

To supervise the phone cord, use an

RJ38X jack.

Figure 12: Phone Connector, Phone LED, and Operation Monitor LED Locations

1211 13 1514 16 1817 19 2120 22

PHONE

LED

RED

ON when

communicating

OFF when idle

PHONE LINE SEIZED

TIP

RING

TELCO

RING

TIP

PHONE LINE

SEIZED

GRN

Point 8

S3 Option

Closed = 1K

EOL

Normal Operation

Open =AB-12 UL

Bell Box 220 K

D5200/D5360

PROG CONN

TELCO CORD

MODEL D161

1 - Phone LED (red)

2 - Telephone cord connector

3 - Operation Monitor LED (green)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Commenti su questo manuale

Nessun commento

Bosch D1255RB Guida di Installazione Pagina 30

Commenti su questo manuale

Prodotti e manuali riguardandi Tastierini numerici Bosch D1255RB