Bosch DS7200V2-EXP Guida Utente Scaricare il pdf (Pagina 127)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 127

Bosch Security Systems | 8/04 | 4998153891C

4.8.4 DX2010 Configuration

DX2010 Configuration Options

• Address:

− 1257 = DX2010 Address 101

− 1258 = DX2010 Address 102

− 1259 = DX2010 Address 103

− 1260 = DX2010 Address 104 (DS7240V2 only)

− 1261 = DX2010 Address 105 (DS7240V2 only)

• Default: 0

• Selections: 0 to 11

Enter This Data Digit to Select Options

DX2010 Configuration Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

300 ms Debounce Time

• • •

150 ms Debounce Time

• • •

75 ms Debounce Time

• • •

30 ms Debounce Time

• • •

Tamper-wired EOL Resistors

• • • •

Single 2.2 k EOL Resistor

• • • •

Single 2.2 k EOL Resistor, 30% Zone

• • • •

Reserved

When the location’s device parameter is set to 2 (see Location ##, Device on page 83), the sensor loop is taken from

a DX2010 module. This parameter configures the input modules. The debounce time selects how quickly the

input reacts to a change.

The single 2.2 k EOL resistor configurations use only one EOL resistor. The tamper-wired EOL resistor

configuration uses two-2.2 k EOL resistors and can report tamper as well as alarm.

The 30% zone causes an alarm whenever the EOL resistance changes by more than 30%. This setting makes the

zone more sensitive to false alarms than a standard zone. The 30% zone should only be used if required by local

regulations.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 155 156

Nessun commento

Bosch DS7200V2-EXP Guida Utente Pagina 127