Bosch PIN8 N1 Guida alla Risoluzione dei Problemi Scaricare il pdf (Pagina 173)

100

101

MPH-02, MPB-02, MPD-02 Motor, Mechanical Axis System, Measuring Systems 5-49

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

Notes on Commissioning

First check whether the third-party motor has been connected according

to manufacturer’s specification.

Note: Third-party motors at IndraDrive controllers should only be

commissioned if the form with the motor output data

completed by the motor manufacturer is available and the

requirements (see "Requirements on Third-Party Motors")

were found to have been fulfilled!

For the commissioning of a third-party motor it is basically the same

procedure as for the commissioning of a Rexroth kit motor that is

applying. The difference is that the motor parameters cannot be loaded

from the motor parameter data base of DriveTop, but have to be

determined by means of one of the mentioned procedures (see

"Determining the Motor Parameter Values").

This is only possible for third-party motors, if motors of the same type

were already operated with controllers of the "Rexroth Diax" or

"Rexroth EcoDrive 03" ranges and therefore the respective motor

parameter values are already existing.

The values are converted with the above formulas, the units, unless

indicated differently, have to be used according to the respective scaling.

The parameter values converted to IndraDrive are input in the drive, e.g.

with the commissioning tool "DriveTop".

For standard asynchronous motors only the type plate data may be

known. In this case it is possible to determine the motor parameter values

on the basis of the data on the type plate. To do this the type plate data of

the rotary asynchronous motor are entered in

• P-0-4032, Type plate list asynchronous motor.

The motor parameter values are calculated by the firmware in phase 2 by

starting

• P-0-4033, C3200 Command Calculate data for asynchronous

motor.

Note: The list of parameters the values of which are calculated can

be found above under "Determining the Motor Parameter

Values by Calculation by Means of Motor Output Data".

Without execution of the command C3200 the values entered

in P-0-4032 are irrelevant!

Note: As a matter of principle it is not allowed to do without the

manufacturer-side output data of a motor! By means of the

detailed output data it is possible to determine the motor

parameter values more exactly.

In addition it is necessary to check whether the motor has the

required dielectric strength!

If the entered type plate data are incorrect, this is displayed by the

respective error messages:

• C3201 Incorrect input for current

• C3203 Incorrect input for voltage

• C3202 Incorrect input for frequency

• C3204 Incorrect input for speed

Converting the Motor Parameter

values from Diax/EcoDrive to

IndraDrive

Determining the Motor

Parameter Values by Entering

the Type Plate Data

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 727 728

Commenti su questo manuale

Nessun commento

Bosch PIN8 N1 Guida alla Risoluzione dei Problemi Pagina 173

Commenti su questo manuale

Prodotti e manuali riguardandi Piani cottura Bosch PIN8 N1