Bosch LTC 1271 Series Manuale di Installazione Scaricare il pdf (Pagina 23)

C2431M-I (4/07) 23

TXB-B ZONE PROGRAMMING PROCEDURE

A zone is a pan area, defined by a left and right limit, on the 360-degree pan plane. To program a zone with

a Bosch (Philips, Burle) controller, refer to the manual supplied with the controller and perform the

following:

IMPORTANT (Spectra and ExSite systems only): After programming a zone, always enable the zone

through the Pelco unit programming menu. Refer to the operation/programming manual supplied with the

Pelco system.

Step Procedure

1. Enter zone programming. Issue the enable zone scan command (ON 60 Enter) to

display the zone labels.

2. Set left zone limit. Position the Pelco unit at the left limit of the zone. Issue the

zone start command (ON 2# Enter) for the zone being

programmed; # is a number between 1 and 8 that represents

zones 1 through 8.

3. Set right zone limit. Position the Pelco unit at the right limit of the zone. Issue the

zone end command (OFF 2# Enter) for the zone being

programmed; # is a number between 1 and 8 that represents

zones 1 through 8.

4. Enable the zone label display. Issue the enable zone scan command (ON 60 Enter) to

display the zone labels.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Nessun commento

Bosch LTC 1271 Series Manuale di Installazione Pagina 23